In a report I had add a parameter as bellow.
Here I need to list only the Vendors which Vendor.VendorClassID = ‘xyz’. But currently it loads all the vendors. How to apply a filtering condition to a parameter
Answer
Add Filter to a parameter in a report
Best answer by Laura03
Hello,
More information about limiting parameters can be found in prior posts on Acumatica Community:
I hope this information helps you.
Laura
+19Hello,
More information about limiting parameters can be found in prior posts on Acumatica Community:
I hope this information helps you.
Laura
~ Laura Barber, WM Synergy
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.