I have a production order with 5 different OP IDs (0010 to 0050). In OP ID 0020, Part A is consumed. At OP ID 0040, it was discovered that Part A was not made correctly and it needs to be scrapped and replaced with a correct Part A. What’s the best way to go about solving this issue?
Answer
Scrapping an Item in a Production Order
Best answer by angierowley75
Part A is a component? Raw material?
You could create a material transaction for the negative quantity. This would remove it from the production order an increase the quantity remaining.
The negative transaction would put the item back to stock - so you would want to issue it out of inventory if no longer usable. (Inventory Issue Transaction).
You would then need to create a material transaction for a positive quantity to issue the good part to the production order operation.
+3Part A is a component? Raw material?
You could create a material transaction for the negative quantity. This would remove it from the production order an increase the quantity remaining.
The negative transaction would put the item back to stock - so you would want to issue it out of inventory if no longer usable. (Inventory Issue Transaction).
You would then need to create a material transaction for a positive quantity to issue the good part to the production order operation.
If I have helped you, please ~ *Like* my post. If I have provided an answer to your question, please mark it as *Best Answer* . Thank you!
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.