Hello, I am new to acumatica, I am preparing for year end inventory, I cannot seem to prepare an inventory that shows all Active inventory Items. I have found that if I do a full physical inventory it actually is not. it leaves out items with 0 on hand. Please anyone.
Answer
Full Inventory Including items with 0 on hand
Best answer by DanielRobinson
On the “Phyiscal Inventory Types” screen, you can create a new type ID, and select the tickbox for “Include Items with Zero Book Quantity in PI”. This is only avaialble for certain generation methods.
I do this with the “By Item Class” generation method, and then list all of my relevant item classes in the table below.
Then you can prepare a phsyical count against for the Type ID you created.
+4
Could you please provide a bit more about the query!
https://www.acumatica.com/acumatica-marketplace/global-payex-ap-accounts-payable-automation-solution/
when we were performing a test Fully Inventory Count we noticed that not all inventory items where on the sheets. Items with 0 on hand did not show on the list. I am struggling to figure out why.
Hi
On the “Phyiscal Inventory Types” screen, you can create a new type ID, and select the tickbox for “Include Items with Zero Book Quantity in PI”. This is only avaialble for certain generation methods.
I do this with the “By Item Class” generation method, and then list all of my relevant item classes in the table below.
Then you can prepare a phsyical count against for the Type ID you created.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.