HI All,
The Screen Sales Order always shows <SPLIT> on the Lot/ Serial Number Column.
There is any way that we can show the content instead of <SPLIT>?
Thank you,
Yên Chi
Best answer by kandybeatty49
View originalHI All,
The Screen Sales Order always shows <SPLIT> on the Lot/ Serial Number Column.
There is any way that we can show the content instead of <SPLIT>?
Thank you,
Yên Chi
Best answer by kandybeatty49
View originalHI
This is standard Acumatica. It does not just happen to Lot/Serial Numbers, it also happens to locations.
The <split> issue is common. I have found an older article in the community that you could read other suggestions.
Allow/Disallow split inventory locations | Community (acumatica.com)
Hi
The <SPLIT> will be shown if a Lot/Serial Nbr. is not selected or if more than one Lot/Serial Nbr. is selected for the same line. If only one Lot/Serial Nbr. is selected, then the content will be shown instead of the <SPLIT>.
HI
We are evaluating Acumatica now, and had a question about line splitting. Currently we sell product with a lot number. We sell most of our products in cases and sometimes as a lot number runs out of stock our current software will split the item into two lines on the pick ticket.
So if our inventory is
Lot 123 = 46 pcs
Lot 231 = 62 pcs
And we sell the product in cases of 20 pcs (ie UOM 20/ cs).
We have a sales order with 4 cases of product requested the pick ticket will show
Pick - Lot 123 - 2.3 cases
Pick - Lot 231 - 1.7 cases
This is really frustrating for our pickers, is this how acumatica does it as well? Does it atleast combine when invoicing?
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.