Vendor 1 and Vendor 2 need to show page 1, then vendor 3 and 4 need to show page 2.but other details show same format
Answer
How to check Tabular Report Columns statical split to page by page print
Best answer by meganfriesen37
Tabular reports have a few limitations around the layouts and columns.
Check out this one here - if you always have the same set of customers, you may be better off hard coding the column settings:
There’s an idea here about page breaks on tabular reports because it doesn’t always follow the page size constraints (though this might be more along the vertical not horizonal page break):
It also looks like you’re trying to do some analysis/totals in the final columns and I’ve never found a good way to do that in a tabular report (it usually has to be on the left, prior to the start of the tabular section.)
+12Tabular reports have a few limitations around the layouts and columns.
Check out this one here - if you always have the same set of customers, you may be better off hard coding the column settings:
There’s an idea here about page breaks on tabular reports because it doesn’t always follow the page size constraints (though this might be more along the vertical not horizonal page break):
It also looks like you’re trying to do some analysis/totals in the final columns and I’ve never found a good way to do that in a tabular report (it usually has to be on the left, prior to the start of the tabular section.)
Megan Friesen, Contego Software Solutions, Canada
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.