DAC browswer unpublished?

Hey ​@kdolgner ,

Can you try to restart the application, clear the caches and then try? If it still persists, then a support ticket with Acumatica would be required.

Hi ​@kdolgner,

If this happens for all DACs, it’s usually not a browser issue. It typically means the customization metadata isn’t properly compiled.

Try:

1. Go to Customization Projects → Publish All.

2. If you have server access, restart IIS and republish.

3. Access the site with ?ClearCache=true.

The DAC Browser relies on compiled customization metadata, so if publishing is incomplete or assemblies are out of sync, this message appears for every DAC.

​@kdolgner as ​@abhimanyuprajapati52 mentioned this is caused by customizations. You can try to reset IIS, which has worked in the past in a couple of cases I’ve worked on, you can try to republish, but ultimately if neither of those options work you need to try to narrow it down to the specific customization causing the issue and review it.

Hmmm. I’ll look into it. The only change of any “customization project” i did was reduce the decimal count on the weight field. Would that really cause a butterfly effect?

​@kdolgner Yes, I’ve seen a few support cases where it was specifically one of their customizations causing the issue, all DAC schema browser became empty due to an issue with one customization