Hi everyone
I am experiencing an issue with Cost Roll.
based on documentation, we should be able to use Cost Roll to update standard cost of BOM item has valuation method set to standard, including material, labour, overhead etc.
When we used Cost Roll, it only seems to roll material cost into standard cost, not labour cost.
Could you please help me and advise what I might be doing wrong here?
Many thanks.
Best answer by angierowley75
It would be best to contact your VAR or Acumatica Support so they can observe the exact steps you are taking, review your data, and provide you with more specific assistance.
+3To what documentation are you referring?
All the cost of a subassembly BOM (labor, overhead, material) is rolled to the material cost of the parent item. The labor and overhead of the subassembly are not retained separately as labor and overhead costs of the parent.
To what documentation are you referring?
All the cost of a subassembly BOM (labor, overhead, material) is rolled to the material cost of the parent item. The labor and overhead of the subassembly are not retained separately as labor and overhead costs of the parent.
Hi Angie
Thank you for reply me so quickly.
Wiki on Cost Roll stated “You can use this form to do the following: Roll up the costs of bills of material (BOMs) based on the costs of the entities included in the BOMs, such as labour or material.”
The BOM we are using is a single level BOM. The labour costs are from the work centres within the BOM, not from a subassembly.
BOM cost calculation accounts for labour - both fixed and variable.
When we tried to Cost Roll, only material cost was rolled onto the pending standard cost of inventory item the BOM defaults to.
Hope this make sense.
+3It would be best to contact your VAR or Acumatica Support so they can observe the exact steps you are taking, review your data, and provide you with more specific assistance.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
