When I try and run this import scenario, I keep running into errors. My upload is only 2 lines but it errors out after importing one line and I have to run it again to complete the second line of import. Any idea on how can I fix this? My XML and import scenario is attached.
Best answer by lauraj46
Hi
I tested your scenario and was able to process multiple lines successfully by deactivating the scenario line that removes the hold. In my exprience, you may need to remove the holds in a separate scenario.
Also, I’m not sure if this is the intended behavior, but I have observed that a BOM can be updated using an iimport scenario without putting it on hold.
Hope this helps!
Laura
+9Hi
I tested your scenario and was able to process multiple lines successfully by deactivating the scenario line that removes the hold. In my exprience, you may need to remove the holds in a separate scenario.
Also, I’m not sure if this is the intended behavior, but I have observed that a BOM can be updated using an iimport scenario without putting it on hold.
Hope this helps!
Laura
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
