We have found that the Mass Change form erroneously converts the UOMs in the BOM to the base UOM instead of leaving it as it was. This is catastrophic for us who use UOM conversions on our Raw Materials that are defined as a 20’ EA on the Stock Item, but in the BOM we consume IN (inches). In the below example the BOM was erroneously changed to consume 272.00 EA (272 20’ pieces) instead of 272.00 IN (inches).
Anyone else out there that has experienced this?
Best answer by angierowley75
The Mass Change is just performing the same function that would happen if you were to manually change the Item on the Bill of Material. If you put a BOM on hold and change the inventory ID of one of the materials, you will see it reassigns the UOM and cost.
I would encourage you to log a Community Idea to see if other users would like to see the behavior enhanced in a future release.
+3The Mass Change is just performing the same function that would happen if you were to manually change the Item on the Bill of Material. If you put a BOM on hold and change the inventory ID of one of the materials, you will see it reassigns the UOM and cost.
I would encourage you to log a Community Idea to see if other users would like to see the behavior enhanced in a future release.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
