When receiving on a handheld in Acumatica (receive and Put Away). There is not the ability to change the unit of measure. That would be fine - except that we find that the quantity shown on the handheld as received always show in the base unit of measurement and not the received unit of measure. This is confusing to our warehouse staff.
Does anyone know if there is a way to expose on the handheld the quantity received in the purchase unit of measure - in addition to the base unit of measure?
Best answer by yhartman
Yes, through a customization you can add the relevant columns and the expose them to the mobile device.
There are two table used for the receiving and put away screen. The main one being POReceiptLineSplit (which only contains the base UOM information), however, the main table POReceiptLine is tied in to the view as well. You may want to modify the column names for clarity.
I hope this helps!
Yes, through a customization you can add the relevant columns and the expose them to the mobile device.
There are two table used for the receiving and put away screen. The main one being POReceiptLineSplit (which only contains the base UOM information), however, the main table POReceiptLine is tied in to the view as well. You may want to modify the column names for clarity.
I hope this helps!
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
