I’m trying to create a Request for Proposal to send to vendors. I want the vendor to quote one item at 2 different quantities.
| Inventory ID | Qty Req’d |
|---|---|
| IM2300 | 25 |
| IM2300 | 50 |
When I click Request for Proposal, the form merges the two lines together as though I want the vendor to provide a quote for 75 of the item.
Is there a way to get the system to keep them as separate lines so I can send one form to a vendor requesting a quote for 25 and 50?
Thanks!
Check the group formulas - in the default requisition design, it’s grouped by inventoryID, subitemID, and UOM, which would be the same in your scenario and cause everything to summarize.
You can adjust these as-needed, but I’d probably use only RQRequisitionLine.LineNbr to keep all lines separate. Both versions are included for reference.
Could you tell me where you found the group formulas/default design? Thanks!
Could you tell me where you found the group formulas/default design? Thanks!
File > Build Schema, then the Sorting and Grouping tab. You can toggle between the different groups and adjust as-needed.
Since the detail is listed on groupHeaderSection2, I went straight to group 2’s setup for review / adjustment.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.