Hello all,
I have been working on a GI where I am referencing a sub-GI. But whenever I apply any filter it throws me the following error:
How to resolve this?
Solved
Error: Multi part identifier could not be bound
Best answer by Nilkanth Dipak
Hi
This might be caused by specific data, as I've tried it in the 24 R1 sales demo instance. After applying filters, the GI is working fine and I'm not encountering any errors.
+11Hi
Please send the xml file of this GI so we can find out the cause of the error.
Best Regards,
NNT
I have devoted my time and deep passion to Acumatica! 🌐 https://www.linkedin.com/in/truongpham80
nhatnghetinh wrote:
Hi
Please send the xml file of this GI so we can find out the cause of the error.
Best Regards,
NNT
Attached are the files.
+11
I have devoted my time and deep passion to Acumatica! 🌐 https://www.linkedin.com/in/truongpham80
nhatnghetinh wrote:
Hey
its just when I filter some value → click OK and then click on any of the column names then the error gets triggered.
+10Hi
This might be caused by specific data, as I've tried it in the 24 R1 sales demo instance. After applying filters, the GI is working fine and I'm not encountering any errors.
Dipak Nilkanth || MVP @2025 || https://www.linkedin.com/in/dipak-nilkanth-293591102 || Acumatica Developer
1 person likes this
I am getting the error The multi-part identifier "PMQuote.QuoteID" could not be bound.
Relationship CROpportunityProducts Inner join PMQuote
Link CROpportunityProducts.QuoteID Equals PMQuote.QuoteID
This worked well on version prior to upgrade to 2024R1.
How can this be resolved On the DAC the QuoteID is visible on both tables
Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.