Hello,
I’m writing a very basic report in the report designer to be used as a subreport later.
It is one table with 2 values on the report in text boxes.
I get the following when I click “preview”
Solved
Report Preview in Report Designer is not working "Response is not a well-formed XML"
Best answer by brucewarrell96
We ran into this when opening the report from the server using lower case in the credentials (i.e. admin@company). Our company ID is in uppercase. We were able to preview once we opened the report using admin@COMPANY
+7@itussing03
Save the report and share it with me so I can check.
There might be an issue with one element. You can start with adding the table only and check if preview show you a blank page and add fields one by one and after each field added check the preview.
SAM KABIRI | L2 Support Engineer | hkabiri@acumatica.com | www.acumatica.com
1 person likes this
+3When I get this message, It is usually a typo in the Value field. such as a left over = or ‘
I have also gotten this when I use a table that is not defined in the scheme. I got this yesterday because I copied a textbox from one report to another prior to adding the table.
1 person likes this
We ran into this when opening the report from the server using lower case in the credentials (i.e. admin@company). Our company ID is in uppercase. We were able to preview once we opened the report using admin@COMPANY
Bruce you ROCKSTAR!
Thank you!!!!
That was it exactly. The tennant had a capitalized letter in the middle.
THANK YOU!!!
If a member helped you, please *Like* their post. If a member provided an answer to your question, please mark it as *Best Answer*.
1 person likes this
Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.