I’m working on ARM report for Balance Sheet by Branch, but outcome is not coming, please advise.
Solved
Balance Report Sheet by Branch
Best answer by vkumar
Hi
One has to check the report definition, Row set and Column set configuration to identify the reason. Since the row set and column set configuration is based on your Chart of accounts, would be bit hard to determine the cause. However, you can check the following :
- Check if your actual Ledger is selected on report definition
- Check the data source on Row set for specific lines ( if its set at line level )
- Check the data source on Column set
- You can compare the configuration with our demo tenant working Balance sheet report to identify / validate the setting.
Hope this helps,
Regards,
Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.