HI All,
The Screen Sales Order always shows <SPLIT> on the Lot/ Serial Number Column.
There is any way that we can show the content instead of <SPLIT>?
Thank you,
Yên Chi
HI All,
The Screen Sales Order always shows <SPLIT> on the Lot/ Serial Number Column.
There is any way that we can show the content instead of <SPLIT>?
Thank you,
Yên Chi
Hi
The <SPLIT> will be shown if a Lot/Serial Nbr. is not selected or if more than one Lot/Serial Nbr. is selected for the same line. If only one Lot/Serial Nbr. is selected, then the content will be shown instead of the <SPLIT>.
HI
This is standard Acumatica. It does not just happen to Lot/Serial Numbers, it also happens to locations.
The <split> issue is common. I have found an older article in the community that you could read other suggestions.
Allow/Disallow split inventory locations | Community (acumatica.com)
We are evaluating Acumatica now, and had a question about line splitting. Currently we sell product with a lot number. We sell most of our products in cases and sometimes as a lot number runs out of stock our current software will split the item into two lines on the pick ticket.
So if our inventory is
Lot 123 = 46 pcs
Lot 231 = 62 pcs
And we sell the product in cases of 20 pcs (ie UOM 20/ cs).
We have a sales order with 4 cases of product requested the pick ticket will show
Pick - Lot 123 - 2.3 cases
Pick - Lot 231 - 1.7 cases
This is really frustrating for our pickers, is this how acumatica does it as well? Does it atleast combine when invoicing?
Hi
In your case, you should set up Base Unit = PCS, Sales Unit = Cases. On-screen Sales Order and Invoice, the system will show only 1 line with unit cases
On the Shipment, the system will show 2 lines w different Lot using Unit = Cases. If you want the Printed Form to show 2 lines using Unit = PCS, you should customize the report joint w SOShipLIneSplit table and showing UOM & QTY from this table
Hope it works for you
We are evaluating Acumatica now, and had a question about line splitting. Currently we sell product with a lot number. We sell most of our products in cases and sometimes as a lot number runs out of stock our current software will split the item into two lines on the pick ticket.
So if our inventory is
Lot 123 = 46 pcs
Lot 231 = 62 pcs
And we sell the product in cases of 20 pcs (ie UOM 20/ cs).
We have a sales order with 4 cases of product requested the pick ticket will show
Pick - Lot 123 - 2.3 cases
Pick - Lot 231 - 1.7 cases
This is really frustrating for our pickers, is this how acumatica does it as well? Does it atleast combine when invoicing?
I run into the same issue with splitting the lots, our sale unit is in cases but the slits are down to eaches.
When this is not caught it causes inventory issues.
We need lot selected but it auto selects & splits the lot. I rather be prompt to select a lot than to have my clerk ignore the split and cause me more wasted time down the line figuring out what happened.
Is there is a setting I'm missing?
HI
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.