I have a created an assignment map for Purchase Requests and assigned it to the Purchase Requisition preferences. No matter how I configure it when I create a request it doesn’t assign it to the workgroup. I can see other areas where Assignment maps are used require a a process to be run to assign the owner and workgroups. . For example, Cases, Contacts, and Opportunities. No such process exists for assigning requests. Any idea on how I can get this to work?
I am with Megan here. An Assignment should not be dependent on the Approval. That’s why there are two different Mapping Options to begin with..
I’m still seeing this issue in 22.113.0040 on Requisitions.
I followed Laura’s instructions above, but we don’t want to add the approval step. I had added a single step to my approval map that would basically never be true and then had as a step action that if no approver was found to approve the document, but that didn’t trigger the reassignment. It only seemed to trigger the assignment if an approver was also assigned.
Is there any other work around?
Thanks all. I will check this out and get back to you.
Hello,
I configured PO Request Assignment with the same result as you. Only when I also configured Approvals for the PO Request, did the Assignment map begin to work. They did not work when I simply checked the ‘require approvals’ box -- I actually had to activate an approval map to get results. I don’t know if this is a ‘bug’ or by design that both must be configured. The steps I used are attached. I tested in 2022 R1 Build 22.108.0024 .
Hi
Turn on the Require Approval on the Preferences:
No luck yet. I have created an assignment map for requests, assigned the map to the purchase requisitions settings. What I would expect is that when I create a request and take off hold it would update the owner and workgroup of the request. It doesn’t. I normally have an employee name in the assignment map but I removed it because this is our customer’s environment.
HI
What are your approval rules and conditions? In my local, here is an example that might help you:
Also, another thing to note below about conditions:
Hi
Hello Brian,
Can you post a picture of
- your tree showing the workgroups, and
- screenshots of the conditions and rule actions tabs of Approval Maps, and
- The requisition that meets the criteria (showing the conditions met), and
- The Approvals tab of the requisition showing to whom it is being directed for approval
Seeing the configurations will make it easier to answer your questions.
Thank you.
Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.