Skip to main content

Hi everyone,

Did you miss our Acumatica Community Webinar - Inventory Optimization with Acumatica Inquiries? Check out the recording below!

 

Inventory Turnover, what is it?

How to use Inquiries including Inventory Turnover and Dead Stock to leverage better control on inventory.

Ways to handle dead stock.

 

 

Our presenter is Kandy Beatty, one of our community power users. You've probably all seen Kandy helping others with questions in the community. Below is a bit about Kandy.

Kandy Beatty: I learned about finances and distribution while serving as a Logistics Specialist in the US Navy for more than 8 years on active duty. That inspired me to learn Acumatica and become passionate about consulting. I received Summa Cum Laude when I received my Technical Management Bachelor's degree last year.  My husband and I have four children in total, ages 15 to 27, and an English Bulldog named Winston. We have been married for seven years. In our spare time, we like to travel and see new places, Hawaii being my favorite thus far.

Hi Chris,

 

   Is the “inventory turnover” only available on 2023 R1?


Hi @qstee I believe this was shown on 2022 R2. @kandybeatty49 can you confirm? Thank you!


Hi Chris,

 

   Is the “inventory turnover” only available on 2023 R1?

Hi @qstee 

It was shown on 2022 R2. You should have it as long as the Inventory Module is turned on. 


@Chris Hackett thanks for sharing!


Will the customization for Inventory Turnover be made available for 2022 R1? 

My client is on 2022 R1 Build 22.114.0029.  Upgraded to 2022 R1 on Sept 23 2022. Client did not want to upgrade to 2022 R2 as it has only been just released (2022-09-15).

Client has customizations that were tested on 2022 R1 and needed to migrate from 2020 R1 and di not have time or resources to re-test customizations on 2022 R2.

Client is asking for an Inventory Turnover inquiry / report. 

Would be great if the customization for Inventory Turnover could me made available for 2022 R1.


Hi @Tfahey14 - I’m not sure you’re going to get an answer to your question here. You may want to inquire with Support if not.


Thanks, @Chris Hackett.  I will inquire with Support.

 


Reply